The automatic silage baler is a new type of silage baler improved by Shenglong Machinery. The original hemp rope binding time is 18 seconds, and now the network wire is only 5 seconds. The production efficiency has more than doubled. It can wrap up very crushed forages sturdyly, with less leakage and greater cost savings.
Product Usage
Straw silage baler is currently the only domestic equipment that can reliably bind the corn stalk after rubbing by the kneading machine. This product has been carefully designed by the technical staff. The whole machine is made of aluminum alloy pressure rollers. , So that the materials can enter the baling room evenly and quickly, which has the advantages of fast baling speed, no clogging of materials, and high density. In addition, we also learned that the reasonable structure of this straw baler avoids the phenomenon that the bale density of other balers is small after bundling and it is easy to mold after coating. The density of corn straw after bundling is large, which is convenient for coating silage; Other dry and fresh grasses can also be bundled, which is one of the necessary equipment for animal husbandry.
Matters needing attention during use of straw silage baler:
1. Before using this machine, please read the instruction manual of this product. Only after you understand the operation and use of this machine and precautions can you use this machine.
2. The operator must understand the signs on the product, such as refueling and other precautions, and operate the machine according to the regulations.
3. Before testing the machine, check whether all parts are firm and reliable, and add enough lubricating oil to power on the machine.
4. Before testing the machine, first pull the clutch handle to check whether the motor rotation direction meets the requirements. It is forbidden to reverse the motor.
5. Before each work, you should run the vehicle empty for 2 ~ 3 minutes to make sure that the machine rotates smoothly without any other abnormalities.
6. After testing 3 to 5 bundles, the machine should be stopped to check whether there are other abnormalities in the rotating parts and fixed parts; if there is no abnormality, it can be put into production.
7. If the machine is powered by a motor, install a ground wire at the marked ground on the machine.
8. It is strictly prohibited to operate this machine after drinking.
9. The machine should be maintained after the normal production of 2000 bundles. Re-use, still operate according to the provisions of 3, 4, 5, 6, 7.
Maintenance and inspection content:
(1) Check the meshing conditions of the chain and sprocket, and replace those with more serious wear.
(2) Check the axial and radial clearance of each shaft, adjust or replace it.
(3) Whether the oil passages are smooth.
(4) Remove all protective covers and remove obstructions.
(5) Add lubricating oil to each rotating part and apply anti-rust oil to other parts
10. It is strictly forbidden to touch the rotating parts by hand when using the machine.
11. In use, the wheels and fixed supports should be locked firmly.
12. If overloading and stalling occurs during operation, immediately pull the clutch handle to make the clutch in the disengaged state, and then release and start the machine. If the machine fails to start twice, the warehouse should be opened immediately and bundled. Otherwise, the machine parts and motor will be seriously damaged.
13. Every half hour of operation, the small silt under the feed roller of the straw silage baler should be removed once to reduce the resistance caused thereby. At the same time, the wear of the lower aluminum roller is also reduced.
